DCS 'Data Centre Cooling Innovation of the Year 2019' Winner
Transtherm manufacture packaged cooler and pump sets to cool immersion cooling, on-chip liquid cooling, rear door cooling systems, CRAC units and water-cooled chillers
Schneider PLC based control systems are used to give seamless operating and fault data
Annualised energy and water consumption data is provided to allow accurate PUE and WUE analysis
Cooling equipment is one of the largest considerations when designing and building data centres.
Whether rejecting heat from CRAC, direct liquid chip, immersion cooling and water-cooled chiller systems or offloading chilled water systems in the cooler months, primary concerns when specifying evaporative coolers and free coolers include:
Latest EC fans use only the minimum amount of power needed. Extended heat exchange surface area means that they can be reduced in speed further
Evaporative cooling operation for typically 3% of the year vs. between 50-100% with other technologies
Use a larger number of smaller direct drive fans, rather than fewer belt-driven fans found in cooling towers and many hybrid coolers
No continuous chemical treatment, No need to outsource maintenance, Reduced serviceable items, No registration with local authorities
Market and project research has shown that Transtherm adiabatic coolers are half the cost of wetted surface hybrid coolers
With massively reduced water consumption, reduced energy consumption and minimal maintenance
Best value for smaller capacities, vertical air discharge
Best value for smaller capacities, horizontal air discharge
Best cooling densities, footprint and value for medium and large capacities
Perfect when sited against a wall due to horizontal air inlet on one side and vertical air outlet
Nordic Protable HPC Data Centre
Two Half V-Adiabatic Coolers with bespoke Pump Skid in a single frame to support a combined 1.2 MW of IT capacity, managed by a built-in smart redundancy PLC program for maximum uptime and reliability.
Transtherm’s adiabatic technology is an efficient, reliable and high-quality solution for directly cooling data centres in which the server temperature parameters allow for the eradication of compressor or refrigerant based technologies.
Their designs are based on real time weather data for the installation site and their knowledgeable team of mechanical engineers can quantify any specification decision with independent research and testing results for complete peace of mind.
Error: Contact form not found.
Transtherm’s adiabatic coolers are a low maintenance, modern alternative to traditional cooling towers and offer lower Legionella risk and OPEX
